Audi Q5 car check
Find out if a Audi Q5 has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.
Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.
- Typical price
- £23,5041,003 at dealers
- MOT failure rate
- 13.4%230k tests
- Known problems
- 9across 8R to FY
- Full report
- £7.49one-off, no subscription
Which Q5 are you looking at?
Each Q5 generation has its own weak spots. Pick the one you’re viewing to see what to check.
-
Oil pump chain failure and DPF issues
Safety risk 8RThe balance shaft oil pump chain on EA189/EA288 diesel engines can fail catastrophically without warning, causing complete loss of oil pressure and engine seizure. This chain drives the oil pump from the crankshaft and its failure leaves the engine with no lubrication. The issue affects 2.0 TDI engines across the VAG range and is most common on urban-driven vehicles where DPF regeneration cycles stress the engine. When combined with DPF clogging on urban-driven cars, repair costs can exceed £4,000.
What to check: Check the oil level on the dipstick - engines with failing oil pump chains often consume oil rapidly as seals fail under reduced pressure. Ask about recent oil pressure warning lights or any instances of the engine going into limp mode. Request service history showing DPF regeneration cycles or a...
-
Front coil spring fracture
Safety risk 8R, FYMOT data shows Q5 models fail spring inspections at 42.9 times the national fleet average, with 3.0L petrol variants worst affected at low mileage (20,000-40,000 miles). Front coil springs fracture due to corrosion and fatigue, particularly where the spring mounting points collect road salt and debris. The Q5's weight and suspension geometry place higher loads on the springs than equivalent saloon cars. Fractured springs can cause sudden loss of vehicle control and tyre damage.
What to check: Inspect both front coil springs visually for cracks, breaks, or missing coils. Use a torch to examine the entire length of each spring, particularly around the mounting points. Check for uneven ride height between left and right sides indicating a collapsed or broken spring. Look for signs of rec...
-
Oil consumption and timing chain failure
Engine damage risk 8RThe EA888 2.0 TFSI engine suffers from defective piston ring design that causes excessive oil consumption (up to 1 litre per 1,000 miles) combined with timing chain tensioner failure. Pre-2013 engines are worst affected due to earlier piston ring specifications and chain tensioner design. The timing chain stretch can cause the engine to jump timing, resulting in valve damage. This is the same fundamental issue affecting A4, A5, and other VAG models with the EA888 engine.
What to check: Check oil level on dipstick - look for signs of recent top-ups or low oil despite recent service. Ask owner about oil consumption rates between services. Remove oil filler cap and inspect for excessive sludge buildup indicating poor oil quality from consumption issues. Ask specifically about timi...
-
Timing chain at rear and EGR failure
Engine damage risk 8RThe 3.0 V6 TDI engine has its timing chain located at the rear of the engine block, making replacement an engine-out procedure costing £3,000-£4,000. The chain tensioner and guides wear over time, causing timing chain rattle and eventual stretch. This is combined with EGR valve clogging that reduces power and triggers fault codes. Unlike four-cylinder engines where timing chain work can be done with the engine in situ, the V6 requires complete engine removal for access.
What to check: Ask about any timing chain rattle noises, particularly on cold starts or when the engine is switched off. The noise comes from deep within the engine, not from the front timing cover. Request service history showing any EGR-related work or fault codes. Check if the engine has been recently servic...
-
Turbo failure
Engine damage risk 8RThe 3.0 V6 TDI biturbo engines use two smaller turbochargers instead of one large unit. Both turbochargers can fail independently, typically due to oil feed problems, carbon buildup, or bearing wear. Early symptoms include loss of power, excessive smoke, and turbocharger whining noises. The twin-turbo setup means higher repair costs as both units often require attention around the same time due to similar operating conditions.
What to check: Check for any oil residue around the exhaust tailpipes indicating turbo oil seal failure. Ask about recent power loss, smoke, or unusual noises during acceleration. Check the air intake system for excessive oil contamination that indicates turbo seal failure.
-
S-tronic mechatronic failure
Wear item 8R, FYThe S-tronic dual-clutch transmission uses a mechatronic unit that combines hydraulic control valves with electronic control modules in a single housing. This unit commonly fails due to valve body wear, solenoid failure, or electronic control issues, causing jerky gear changes, hesitation, and clunking noises. The mechatronic unit is the most expensive single component in the S-tronic system and failure typically requires complete replacement rather than repair.
What to check: Ask about any recent transmission warning lights, jerky gear changes, or hesitation during gear shifts. Check service history for S-tronic fluid changes - irregular servicing accelerates mechatronic failure. Ask specifically about performance in stop-start traffic where mechatronic issues are mos...
-
CV joint boot failure and joint wear
Wear item 8R, FYMOT data shows Q5 models fail CV joint boot inspections at 5.8 times the fleet average, with failures occurring across all engine variants and mileage ranges. The rubber CV joint boots split or tear, allowing grease to escape and dirt to contaminate the constant velocity joints. Once contaminated, the CV joints develop wear and clicking noises, particularly when turning. The Q5's higher ride height and longer driveshaft angles place additional stress on the CV joint boots compared to conventional cars.
What to check: Inspect all four CV joint boots (inner and outer on each side) for splits, tears, or grease leakage. Look for black grease deposits around the wheels or on the inside of wheel arches. Check that the boots are properly seated in their grooves and not twisted or displaced. Look for recent grease sp...
-
Brake pad and disc wear
Safety and MOT risk 8R, FYMOT data shows Q5 models fail brake pad inspections at up to 4.9 times the fleet average, particularly affecting 3.0L petrol variants at low mileage. The Q5's weight (1,760kg+) and performance-oriented braking system cause accelerated pad and disc wear compared to lighter vehicles. Front brake pads typically last 25,000-40,000 miles versus 40,000-60,000 miles on lighter cars. The large diameter discs are expensive to replace and prone to warping under heavy use.
What to check: Inspect brake discs through the wheel spokes for scoring, grooving, or excessive wear. New discs should be smooth and uniform in thickness. Look for brake pad wear indicators or any visible pad material - pads worn to the metal backing will damage the discs. Check for brake dust accumulation on t...
-
Water ingress and electrical module failure
Electrical 8R, FYNHTSA complaints document water leaking into rear battery compartments, trunk fuse bays, and passenger footwells causing electrical module failures. Water ingress typically occurs through worn windscreen seals, clogged sunroof drains, or failed door seals. Once water reaches electrical modules, it causes corrosion and component failure affecting airbag systems, infotainment, and body control modules. The Q5's complex electrical architecture makes water damage particularly expensive to repair.
What to check: Check all footwells for dampness or water staining, particularly on the passenger side where drain blockages commonly cause flooding. Inspect the boot area for water damage, corrosion on electrical connections, or musty odours indicating previous water ingress. Check windscreen seal condition aro...
We haven’t flagged any common problems for this generation in our data yet. A history check still tells you about finance, write-offs and theft, and the MOT history shows how this particular car has been looked after.
What Q5s cost at dealers now
From 1,003 used Q5s we track on UK dealer websites.
- Typical asking price
- £23,504
- Typical mileage
- 52,773 miles
- Price change vs last month
- -5.7%
Q5 MOT results
of Q5 MOT tests end in a fail, from 230,022 tests.
Most common reasons for failing
- Coil springs brokenSuspension
- Reversing lamp lens defectiveLights & Electrics
- Reversing lamp inoperativeLights & Electrics
Check the Q5 you’re buying
One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.
Finance, stolen, write-off and owner history data provided by Experian.
What the check includes
- Outstanding finance Experian
- Write-off status Experian
- Stolen vehicle check Experian
- Previous owners and keeper history Experian
- MOT history and advisories DVSA
- Mileage check DVSA
- Known problems for its generation GetCarWise
- How many are left on the road DVLA
Q5 questions
Is the Audi Q5 reliable?
13.4% of Q5 models fail their MOT based on 230,022 tests analysed. That’s better than average for the class. There are 9 known problems to watch for, the most serious being oil pump chain failure and dpf issues. A full history check shows whether a specific car has had related write-offs or insurance claims.
What are the main problems with a Audi Q5?
The most serious known issues are oil pump chain failure and dpf issues, front coil spring fracture, oil consumption and timing chain failure. Problems vary by generation, so check which apply to the year you’re looking at. Our car check flags whether a specific Q5 has been written off or had insurance claims linked to these faults.
How do I check if a Audi Q5 has outstanding finance?
Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.
How do I check if a Audi Q5 has been written off?
Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N Q5 has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.
Can I check a Audi Q5 for free?
You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.
What does a Audi Q5 fail its MOT on?
The most common MOT failure on the Q5 is coil springs broken. 13.4% of Q5 models fail overall, based on 230,022 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.
More on the Q5
Other Audi car checks
Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.