Home/Car check/Audi/A5

Audi A5 car check

Find out if a Audi A5 has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.

Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.

Typical price
£18,922868 at dealers
MOT failure rate
16.9%367k tests
Known problems
10across B8
Full report
£7.49one-off, no subscription

Which A5 are you looking at?

Each A5 generation has its own weak spots. Here are the known problems.

  1. Timing chain tensioner failure

    Safety risk B8

    The EA888 Gen1 and Gen2 engines use hydraulic timing chain tensioners that fail catastrophically between 50k-120k miles. The tensioner loses oil pressure, allowing the timing chain to jump teeth or snap completely. This destroys pistons, valves, and often requires complete engine replacement. The issue is most severe on 2008-2013 models and affects both 1.8 TFSI and 2.0 TFSI variants. Later EA888 Gen3 engines (2013 onwards) have revised tensioners but are not immune.

    What to check: Ask about any recent timing-related fault codes or engine management light activation. The car should have comprehensive service history showing regular oil changes. Check the oil level and condition on the dipstick - low or contaminated oil accelerates tensioner wear. Ask specifically about any ...

  2. Rear spring fracture

    Safety risk B8

    MOT data shows A5 models failing spring inspections at over 26972.7x the national fleet average, indicating a serious structural defect. Spring fractures can cause complete loss of suspension control, wheel alignment problems, and potential tyre damage. The issue affects multiple engine variants and appears across all mileage bands, suggesting a fundamental design or material problem rather than normal wear. A fractured spring is a dangerous defect that makes the vehicle unsafe to drive.

    What to check: Walk around the car and check that it sits level - one corner sitting noticeably lower may indicate a broken spring. Look through the wheel arches at the coil springs for any visible cracks, fractures, or separated coils. Check for any unusual tyre wear patterns that might indicate suspension pro...

  3. Excessive oil consumption

    Engine damage risk B8

    EA888 Gen1 and Gen2 engines suffer from defective piston rings that allow excessive oil consumption, typically exceeding 1 litre per 1000 miles. The oil control rings become clogged with carbon deposits, failing to properly seal against the cylinder walls. This causes blue smoke on startup and acceleration, frequent low oil warnings, and potential engine seizure if oil levels drop critically. The issue is worst on 2008-2012 models and affects both 1.8 TFSI and 2.0 TFSI variants.

    What to check: Check the oil level immediately on the dipstick - it should be between minimum and maximum marks. Ask the owner how frequently they need to top up the oil. Look for oil staining around the exhaust tailpipe indicating oil being burned in the combustion chambers. Request service records showing oil...

  4. Timing chain stretch and rattle

    Engine damage risk B8

    The 3.0 V6 TDI engine has its timing chain assembly located at the rear of the engine block, making access extremely difficult and expensive. The timing chain stretches over time, causing rattling noises and eventually jumping teeth which destroys the engine. This is a known weak point on high-mileage V6 TDI engines and requires complete engine removal for repair. The repair cost often exceeds the vehicle's value, making this a critical inspection point for any high-mileage V6 TDI A5.

    What to check: Ask specifically about any engine rattling noises, particularly on cold startup or when the engine is switched off. Request evidence of any timing chain inspection or replacement work. Check service history for regular oil changes - poor maintenance accelerates chain wear. Ask about any recent en...

  5. Water pump and coolant pump failure

    Wear item B8

    EA888 engines use plastic water pump housings that are prone to cracking and failure, typically between 50k-100k miles. The plastic becomes brittle over time and develops stress cracks that cause coolant leaks and overheating. Some variants also have auxiliary electric coolant pumps that fail independently. Water pump failure can cause serious engine damage if the engine overheats, making this a critical maintenance item on all EA888-equipped A5 models.

    What to check: Check the coolant reservoir level - it should be between minimum and maximum marks. Low coolant may indicate a leak or previous overheating. Look under the car for pink/green coolant puddles, particularly around the front of the engine. Check the coolant condition in the reservoir - it should be ...

  6. Carbon buildup on intake valves

    Engine damage risk B8

    Direct injection petrol engines inject fuel directly into the combustion chamber, bypassing the intake valves. This means the intake valves never get washed with fuel and accumulate carbon deposits over time. The carbon buildup restricts airflow, causing rough idle, hesitation, misfiring, and power loss. All direct injection A5 engines require periodic carbon cleaning using walnut shell blasting or chemical cleaning. The issue is progressive and affects all direct injection variants including EA888, 3.2 FSI, and 4.2 V8 engines.

    What to check: Ask whether carbon cleaning (walnut blasting) has ever been performed and request documentation. Check for any engine management warning lights or recent fault codes related to misfiring or lambda sensors. Ask about any noticed power loss, rough idle, or hesitation during acceleration.

  7. EGR and DPF clogging

    Engine damage risk B8

    Diesel A5 models suffer from EGR valve clogging and DPF (Diesel Particulate Filter) blockage, particularly when used for short urban journeys. The EGR valve recirculates exhaust gases and becomes clogged with carbon and soot, causing rough running and fault codes. The DPF requires regular high-temperature regeneration cycles that only occur during sustained highway driving. Cars used primarily for short journeys cannot complete regeneration cycles, leading to DPF blockage and expensive replacement.

    What to check: Ask about the car's typical usage pattern - short urban trips increase the risk of EGR and DPF problems. Check for any DPF warning lights on the dashboard or recent DPF regeneration messages. Ask about any recent loss of power, rough running, or black smoke from the exhaust. Request evidence of a...

  8. Timing chain tensioner and carbon buildup

    Engine damage risk B8

    The 3.2 V6 FSI engine combines two expensive problems: timing chain tensioner failure and severe carbon buildup on intake valves. The timing chain is located at the rear of the V6 engine requiring engine removal for service, making repairs extremely costly. Additionally, the direct injection system causes carbon deposits on intake valves that restrict airflow and reduce performance. Both issues typically manifest between 60k-120k miles and often require simultaneous repair.

    What to check: Ask about any timing chain rattle or engine management warning lights. The service history should show evidence of carbon cleaning or timing chain work. Request documentation of any previous engine-out repairs which indicate the severity of timing chain access issues. Check for any noted power lo...

  9. Carbon buildup and oil consumption

    Engine damage risk B8

    The 4.2 V8 and 3.0 TFSI engines suffer from severe carbon buildup on intake valves due to direct injection, combined with oil consumption issues similar to the EA888 engines. The V8 engines are particularly affected by carbon deposits that cause significant power loss and require expensive walnut shell blasting to resolve. Oil consumption becomes noticeable at higher mileages and can lead to timing chain noise if oil levels drop too low.

    What to check: Check oil level on dipstick and ask about oil consumption patterns and top-up frequency. Ask whether carbon cleaning (walnut blasting) has been performed and request documentation. Look for oil staining around exhaust tailpipes indicating internal oil burning. Request evidence of regular oil chan...

  10. Shock absorber failure

    Wear item B8

    MOT data shows A5 shock absorbers failing at 26972.7x the national average, with 265 recorded failures across multiple variants. The dampers develop leaks or complete failure, causing poor ride quality, increased stopping distances, and handling problems. The issue affects all engine variants and appears particularly severe on higher-mileage examples. Failed shock absorbers are a significant safety concern affecting vehicle stability and braking performance.

    What to check: Visually inspect each shock absorber for oil leaks, particularly around the piston rod and mounting points. Check for any obvious physical damage to the shock absorber bodies or mounting hardware. Push down firmly on each corner of the car - it should return to rest position without bouncing. Con...

What A5s cost at dealers now

From 868 used A5s we track on UK dealer websites.

Typical asking price
£18,922
Typical mileage
51,690 miles
Price change vs last month
-9.1%

A5 MOT results

16.9%

of A5 MOT tests end in a fail, from 367,400 tests.

Most common reasons for failing

  1. Fluid leakSuspension
  2. Coil springs brokenSuspension
  3. Exhaust system damageBodywork

Check the A5 you’re buying

One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.

Finance, stolen, write-off and owner history data provided by Experian.

What the check includes

A5 questions

Is the Audi A5 reliable?

16.9% of A5 models fail their MOT based on 367,400 tests analysed. That’s about average for the class. There are 10 known problems to watch for, the most serious being timing chain tensioner failure. A full history check shows whether a specific car has had related write-offs or insurance claims.

What are the main problems with a Audi A5?

The most serious known issues are timing chain tensioner failure, rear spring fracture, excessive oil consumption. Our car check flags whether a specific A5 has been written off or had insurance claims linked to these faults.

How do I check if a Audi A5 has outstanding finance?

Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.

How do I check if a Audi A5 has been written off?

Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N A5 has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.

Can I check a Audi A5 for free?

You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.

What does a Audi A5 fail its MOT on?

The most common MOT failure on the A5 is fluid leak. 16.9% of A5 models fail overall, based on 367,400 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.

More on the A5

Other Audi car checks

Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.