Peugeot 3008 car check
Find out if a 3008 has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.
Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.
- Typical price
- £16,5912,716 at dealers
- MOT failure rate
- 22.1%352k tests
- Known problems
- 10across T84 to Mk2
- Full report
- £7.49one-off, no subscription
Which 3008 are you looking at?
Each 3008 generation has its own weak spots. Pick the one you’re viewing to see what to check.
-
Timing chain failure
Safety risk T84The 1.6 THP engine uses a timing chain system that is prone to excessive stretch due to undersized tensioner components and inadequate oil pressure at the chain guides. Chain stretch of more than 0.6 degrees causes the engine to jump timing, resulting in catastrophic valve and piston damage. This is a well-documented failure mode across the PSA 1.6 THP family, with the EP6DT variant in the T84 3008 being particularly susceptible. The issue was partially addressed in later revisions but remains a significant concern on higher-mileage examples.
What to check: Check the oil level and condition on the dipstick - metallic debris or unusually dark oil may indicate chain wear causing metal contamination. Ask for evidence of timing chain inspection or replacement, looking specifically for PSA diagnostic printouts showing chain stretch measurements. Request ...
-
Timing belt (wet) issues
Safety risk Mk2The 1.2 PureTech three-cylinder engine uses a timing belt that runs in engine oil (wet belt system) instead of a traditional dry timing belt. The belt material deteriorates in the oil environment, particularly when service intervals are extended or incorrect oil specifications are used. Belt failure is catastrophic on this interference engine, causing extensive valve and piston damage. This design flaw affects the entire PSA PureTech range and has been the subject of significant owner complaints and specialist warnings.
What to check: Check the engine oil condition on the dipstick for any black rubber particles or debris that could indicate belt material breakdown. Look for any oil leaks around the timing belt cover area on the front of the engine. Request service history showing oil changes at recommended intervals using PSA-...
-
EGS gearbox issues
Wear item T84The EGS (Efficient Grip System) automated manual gearbox fitted to many T84 3008 models suffers from actuator and clutch control problems. The system uses electro-hydraulic actuators to operate the clutch and select gears, but these components are prone to failure, causing jerky gear changes, clutch slip, and complete loss of drive. The EGS system was known for poor reliability across the PSA range and was eventually discontinued in favour of conventional automatics and DSG-type transmissions.
What to check: Check for any warning lights on the dashboard related to gearbox function - the EGS system has dedicated warning displays. Ask the seller about any recent gearbox servicing or actuator replacements, requesting invoice documentation. Look for evidence of clutch burning smell around the vehicle whi...
-
DPF issues
Wear item T84, Mk2Diesel Particulate Filter (DPF) blockage is a persistent problem across all PSA diesel engines, particularly on vehicles used predominantly for short journeys. The DPF requires regular high-temperature regeneration cycles to burn off accumulated soot, but insufficient motorway driving prevents proper regeneration. T84 and early Mk2 models are particularly susceptible due to the regeneration system design and the typically urban usage pattern of crossover vehicles.
What to check: Check the dashboard for any DPF warning lights or service messages - many PSA vehicles display DPF status information. Ask about driving patterns - vehicles used mainly for school runs or short urban trips are high risk for DPF problems. Request evidence of recent DPF servicing or regeneration pr...
-
EGR failure
Engine damage risk T84The Exhaust Gas Recirculation (EGR) valve on T84 diesel engines is prone to carbon buildup and mechanical failure, causing poor engine running, excessive emissions, and ultimately MOT failure. The EGR system recirculates exhaust gases back into the combustion chamber to reduce NOx emissions, but the valve mechanism becomes clogged with carbon deposits over time. This is exacerbated by short journey patterns and poor fuel quality, common in UK urban driving conditions.
What to check: Check for any engine management warning lights on the dashboard which commonly appear with EGR faults. Request service history showing evidence of EGR cleaning or replacement if any running problems have been noted. Ask about driving patterns - vehicles used for frequent short journeys are more p...
-
AdBlue issues
Wear item Mk2The AdBlue (urea injection) system fitted to Euro 6 diesel engines in Mk2 3008 models is prone to injector blockage, tank contamination, and sensor failures. AdBlue crystallises when exposed to heat or contamination, blocking the fine injector nozzles and causing the system to fail. The vehicle will not start if the AdBlue system detects a fault, making this a critical reliability issue. Quality control problems with some AdBlue suppliers and the system's sensitivity to contamination make this a widespread problem across the PSA Euro 6 diesel range.
What to check: Check the dashboard for AdBlue warning messages or remaining range displays - the system typically warns when fluid levels are low or faults are detected. Ask about AdBlue top-up history and what brand of fluid has been used - non-specification fluid can cause system damage. Look for any white cr...
-
Electronic parking brake failure
Safety and MOT risk T84, Mk2The electronic parking brake system fitted to 3008 models across both generations suffers from actuator motor failures and software glitches, causing the handbrake to become inoperable. MOT data shows this model fails at 54.6 times the fleet average for parking brake control defects, with failures occurring across all engine variants and mileage ranges. The system uses electric motors to apply and release the rear brake calipers, but these motors are prone to seizing due to corrosion and wear.
What to check: Test the electronic parking brake button to ensure it operates smoothly in both apply and release directions, listening for motor operation sounds. Check for any warning lights on the dashboard relating to parking brake function. Look for any obvious corrosion or damage to the rear brake calipers...
-
Air suspension failure
Wear item T84Certain 2.0L diesel variants were fitted with rear air suspension as standard or optional equipment. The pneumatic system uses air bags, height sensors, and a compressor unit that are all prone to failure, causing the rear of the vehicle to sag and affecting handling and ride quality.
What to check: Check the rear ride height by comparing both sides - uneven height or obvious sagging indicates air bag or system failure. Look under the rear of the vehicle for any obvious air lines, compressor units, or height sensors that show damage or corrosion. Check for any suspension warning lights on th...
-
Suspension bush wear
Wear item T84, Mk2MOT data shows the 3008 fails at 16.1 times the fleet average for suspension bush wear, with failures occurring unusually early in the vehicle's life, including at 20,000-40,000 miles. The front lower arm bushes and rear trailing arm bushes are particularly prone to premature deterioration, causing knocking noises, poor handling, and uneven tyre wear. This affects all engine variants and suggests a design or material quality issue with the suspension mounting components.
What to check: Perform a visual inspection of the front lower arms and rear suspension links, looking for obvious splits, cracks, or deterioration in the rubber bushes. Check the tyre wear pattern for signs of poor alignment or camber issues that indicate bush failure. Push down on each corner of the vehicle an...
-
CV joint boot failure
Wear item T84, Mk2MOT data shows the 3008 fails at 8.6 times the fleet average for CV joint boot defects, with failures occurring across all engine variants from as low as 20,000 miles. The rubber boots protecting the constant velocity joints are prone to splitting, allowing grease to escape and dirt to contaminate the joint. This appears to be a material quality issue affecting the entire 3008 range, with particularly high failure rates on 1.6L diesel variants.
What to check: Inspect the CV joint boots at each front wheel by looking behind the wheel for split or damaged rubber boots - fresh grease splatter around the wheel arch indicates recent boot failure. Check for any clicking or knocking sounds when turning the steering on full lock while stationary - this indica...
We haven’t flagged any common problems for this generation in our data yet. A history check still tells you about finance, write-offs and theft, and the MOT history shows how this particular car has been looked after.
What 3008s cost at dealers now
From 2,716 used 3008s we track on UK dealer websites.
- Typical asking price
- £16,591
- Typical mileage
- 33,344 miles
- Price change vs last month
- -10.4%
3008 MOT results
of 3008 MOT tests end in a fail, from 352,284 tests.
Most common reasons for failing
- Fluid leakSuspension
- Parking brake inefficientBrakes
- Brake hoses perished or damagedBrakes
Check the 3008 you’re buying
One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.
Finance, stolen, write-off and owner history data provided by Experian.
What the check includes
- Outstanding finance Experian
- Write-off status Experian
- Stolen vehicle check Experian
- Previous owners and keeper history Experian
- MOT history and advisories DVSA
- Mileage check DVSA
- Known problems for its generation GetCarWise
- How many are left on the road DVLA
3008 questions
Is the Peugeot 3008 reliable?
22.1% of 3008 models fail their MOT based on 352,284 tests analysed. That’s about average for the class. There are 10 known problems to watch for, the most serious being timing chain failure. A full history check shows whether a specific car has had related write-offs or insurance claims.
What are the main problems with a Peugeot 3008?
The most serious known issues are timing chain failure, timing belt (wet) issues, egs gearbox issues. Problems vary by generation, so check which apply to the year you’re looking at. Our car check flags whether a specific 3008 has been written off or had insurance claims linked to these faults.
How do I check if a Peugeot 3008 has outstanding finance?
Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.
How do I check if a Peugeot 3008 has been written off?
Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N 3008 has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.
Can I check a Peugeot 3008 for free?
You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.
What does a Peugeot 3008 fail its MOT on?
The most common MOT failure on the 3008 is fluid leak. 22.1% of 3008 models fail overall, based on 352,284 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.
More on the 3008
Other Peugeot car checks
Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.