Home/Car check/Rover/216

Rover 216 car check

Find out if a Rover 216 has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.

Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.

MOT failure rate
29.3%891 tests
Known problems
5across R8
Full report
£7.49one-off, no subscription

Which 216 are you looking at?

Each 216 generation has its own weak spots. Here are the known problems.

  1. Subframe corrosion and mounting point failure

    Safety risk R8

    The steel subframe that carries the front suspension and steering suffers from corrosion particularly around the mounting points to the monocoque. UK road salt and poor drainage design causes structural corrosion that weakens the mounting points beyond safe limits. Complete subframe replacement is often required as welded repairs frequently fail re-inspection.

    What to check: Examine the front subframe from underneath using a torch, looking specifically at the four mounting points where the subframe bolts to the body. Look for brown rust staining, flaky metal, or visible holes in the metal structure. Check around the lower suspension arm mounting points on the subfram...

  2. Catalytic converter failure and excessive emissions

    Wear item R8

    The catalytic converter fails at high mileage causing emissions levels to exceed legal limits by significant margins. 6-litre engines between 80,000-100,000 miles. The catalyst material becomes contaminated or damaged, often due to poor engine condition allowing unburnt fuel or oil to reach the exhaust system. Replacement is mandatory for MOT pass.

    What to check: Check the exhaust system visually for any obvious damage or missing heat shields around the catalytic converter area. Ask when the emissions test was last passed and request any previous MOT certificates showing emission readings. Check for any engine management warning lights on the dashboard.

  3. Brake efficiency below minimum requirement

    Safety and MOT risk R8

    Brake calipers seize due to corrosion of the piston and cylinder bore, particularly the rear drums on early models and front disc calipers on later variants. MOT data shows this model fails brake efficiency tests at 21.7 times the fleet average. Seized calipers reduce braking force and cause uneven braking between sides. The issue is compounded by infrequent brake fluid changes allowing moisture to corrode internal components.

    What to check: Check brake fluid level and colour in the master cylinder reservoir. Dark or contaminated fluid indicates poor maintenance. Examine brake discs for uneven wear patterns, deep scoring, or rust build-up which indicates binding calipers. Look at wheel rims for brake dust patterns - one wheel signifi...

  4. Front suspension ball joint and bush wear

    Wear item R8

    Front suspension components including lower ball joints, anti-roll bar bushes, and control arm bushes wear prematurely on this model. MOT data shows suspension component failures at 17.2 times the fleet average across all mileage bands. The rubber compounds used deteriorate in UK climate conditions causing excessive play and noise. This is a progressive wear issue rather than sudden failure but affects handling precision and tyre wear patterns.

    What to check: Examine the front tyres for uneven wear patterns particularly on the inner or outer edges which indicates suspension geometry problems. Look under the front of the car for any obviously perished rubber bushes - they should be black and flexible, not cracked or oil-soaked. Check for any play in th...

  5. CV joint boot deterioration and failure

    Wear item R8

    The rubber boots protecting the constant velocity (CV) joints on the front driveshafts deteriorate and split, allowing grease to escape and dirt to contaminate the joint. MOT data shows boot failures at 16.1 times the fleet average, with severely deteriorated boots failing at even higher rates. Once contaminated, the CV joint itself fails requiring complete driveshaft replacement rather than just boot replacement.

    What to check: Examine both front driveshafts for split or damaged rubber boots particularly on the outer joints near the wheels. Look for grease splattered around the wheel area which indicates a failed boot. Check that the metal clips securing the boots are still in place and tight. Feel the boot material - i...

216 MOT results

29.3%

of 216 MOT tests end in a fail, from 891 tests.

Most common reasons for failing

  1. Emissions failureExhaust & Emissions
  2. Vehicle structure corroded to the extent that t...Bodywork
  3. Service brake efficiency below minimum requirementBrakes

Check the 216 you’re buying

One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.

Finance, stolen, write-off and owner history data provided by Experian.

What the check includes

216 questions

Is the Rover 216 reliable?

29.3% of 216 models fail their MOT based on 891 tests analysed. That’s below average for the class. There are 5 known problems to watch for, the most serious being subframe corrosion and mounting point failure. A full history check shows whether a specific car has had related write-offs or insurance claims.

What are the main problems with a Rover 216?

The most serious known issues are subframe corrosion and mounting point failure, catalytic converter failure and excessive emissions, brake efficiency below minimum requirement. Our car check flags whether a specific 216 has been written off or had insurance claims linked to these faults.

How do I check if a Rover 216 has outstanding finance?

Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.

How do I check if a Rover 216 has been written off?

Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N 216 has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.

Can I check a Rover 216 for free?

You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.

What does a Rover 216 fail its MOT on?

The most common MOT failure on the 216 is emissions failure. 29.3% of 216 models fail overall, based on 891 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.

More on the 216

Other Rover car checks

Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.