Home/Car check/Mitsubishi/L200

Mitsubishi L200 car check

Find out if a L200 has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.

Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.

Typical price
£18,380188 at dealers
MOT failure rate
25%313k tests
Known problems
9across KB to KL
Full report
£7.49one-off, no subscription

Which L200 are you looking at?

Each L200 generation has its own weak spots. Pick the one you’re viewing to see what to check.

  1. Timing belt service

    Safety risk KB

    The 4D56 2.5-litre diesel engine uses an interference design where pistons and valves occupy the same space at different times. If the timing belt breaks, pistons strike the open valves causing catastrophic internal damage. The belt has a critical replacement interval of 62,500 miles or 5 years, whichever comes first. This is not a maintenance item that can be delayed - failure results in complete engine rebuild costs far exceeding the vehicle's value. The KL generation switched to a timing chain system.

    What to check: Request all service history and look specifically for timing belt replacement receipts. If the belt has never been changed on a vehicle approaching or exceeding 62,500 miles, do not start the engine. Visually inspect the belt through the top of the engine bay - look for any fraying, cracking, or ...

  2. Leaf spring fracture

    Safety risk KB, KL

    The rear leaf spring suspension on L200s is subject to fatigue cracking and complete fracture, particularly the main leaf springs. MOT data shows this model fails at 45.6x the fleet average for main leaf fractures, with the issue worsening over recent years. Heavy loading, off-road use, and corrosion from road salt accelerate spring fatigue. Complete fracture causes immediate loss of rear suspension control and can damage brake lines or fuel lines.

    What to check: Walk around the rear of the vehicle and visually inspect the leaf springs for any obvious cracks, particularly at the spring eyes and centre mounting points. Look for any signs that one side is sitting lower than the other which could indicate a partially fractured spring. Check for any rust stai...

  3. Body structure corrosion

    Safety risk KB, KL

    MOT data shows L200s fail at 33.6x the fleet average for vehicle structure corrosion that seriously reduces assembly rigidity. This affects vehicles across all age groups, including relatively low-mileage examples. The combination of commercial use, exposure to agricultural chemicals, road salt, and mud retention around the chassis creates ideal conditions for rapid corrosion development. Critical structural areas include rear chassis rails, cross-members, and mounting points.

    What to check: Examine the rear chassis rails and cross-members with a torch, looking for any holes, severe scaling, or areas where rust has eaten through the metal completely. Check all suspension and towbar mounting points for corrosion that could compromise structural integrity. Inspect the area around the f...

  4. Turbo failure

    Engine damage risk KB

    The VT12 variable geometry turbocharger on the 4D56 engine is prone to actuator mechanism failure and carbon build-up in the variable vane system. The actuator arm that controls vane position can seize due to carbon deposits and heat cycling, leading to loss of boost pressure and reduced power output. Oil starvation from irregular servicing accelerates bearing wear within the turbo cartridge. This is a well-documented issue on high-mileage KB generation L200s.

    What to check: Check the oil level and condition on the dipstick - turbo failure often follows from oil starvation so look for low levels or contaminated oil. Visually inspect around the turbo housing for oil leaks, particularly where the oil feed and return lines connect. Ask about any recent loss of power or ...

  5. DPF issues

    Wear item KL

    The diesel particulate filter on the 4N15 engine blocks with soot if the vehicle is used primarily for short journeys without reaching full operating temperature. The DPF requires periodic high-temperature regeneration cycles to burn off accumulated particulates, but these cycles fail if interrupted or if the vehicle cannot sustain highway speeds. This is particularly problematic for L200s used in urban commercial applications or as lifestyle vehicles for short trips.

    What to check: Check the dashboard for any DPF warning lights - an illuminated DPF symbol indicates an immediate regeneration requirement. Ask the seller about typical journey patterns - vehicles used primarily for short trips under 10 miles are at highest risk. Request evidence of any recent DPF services or fo...

  6. Injector failure

    Wear item KB

    The common rail diesel injectors on the 4D56 engine are sensitive to fuel quality and contamination. Internal seals deteriorate over time, causing poor fuel atomisation and injection timing irregularities. Contaminated fuel or water ingress accelerates wear of the precision-machined internal components. Failed injectors cause rough running, increased emissions, and can contaminate the fuel rail system affecting other injectors.

    What to check: Check for any diesel fuel odour around the engine bay which could indicate external injector leaks. Ask about recent fuel consumption - failing injectors often cause increased fuel usage. Request any recent diagnostic scan results that might show injector-related fault codes. Look for any recent ...

  7. Transmission bearing wear

    Wear item KB, KL

    MOT data shows the L200 fails at 116.7x the fleet average for transmission shaft bearing wear, particularly affecting 2.5-litre diesel variants. The manual gearbox bearings are subject to high loads from the torquey diesel engine and commercial use patterns including frequent towing and heavy loading. Input shaft and layshaft bearings show premature wear, causing noise and eventual gearbox failure if not addressed.

    What to check: Ask about any recent gearbox noise, particularly whining or grinding sounds during gear changes or while driving. Check the gearbox oil level if accessible - low oil accelerates bearing wear. Request any history of heavy towing or commercial use which increases bearing stress. Look for any oil le...

  8. AdBlue issues

    Engine damage risk KL

    The selective catalytic reduction system on KL generation L200s uses AdBlue fluid injection to reduce NOx emissions. The AdBlue delivery system includes pumps, injectors, and sensors that can fail due to crystallisation of urea deposits or freezing in cold weather. Quality issues with aftermarket AdBlue fluid can also cause system contamination and component failure. The system will prevent engine restart if AdBlue runs empty or if key components fail.

    What to check: Check the AdBlue fluid level in the separate blue-capped filler - low levels trigger dashboard warnings well before empty. Look for any AdBlue warning messages on the dashboard display. Ask about recent AdBlue consumption patterns - abnormal consumption can indicate system leaks. Check for any cr...

  9. Suspension bush wear

    Wear item KB, KL

    The L200 shows MOT failure rates of 132x the fleet average for worn suspension pins, bushes, and joints, affecting all mileage ranges from 20,000 miles upward. The combination of heavy vehicle weight, commercial use patterns, and off-road capability results in accelerated wear of rubber suspension bushes throughout the system. Front lower arm bushes, rear leaf spring bushes, and anti-roll bar bushes are particularly affected.

    What to check: Jack up each corner of the vehicle and check for excessive play in suspension joints by pushing and pulling on the wheels. Visually inspect all visible rubber bushes for cracking, splitting, or displacement from their metal housings. Look specifically at the front lower arm bushes and rear spring...

What L200s cost at dealers now

From 188 used L200s we track on UK dealer websites.

Typical asking price
£18,380
Typical mileage
60,400 miles
Price change vs last month
+3.1%

L200 MOT results

25%

of L200 MOT tests end in a fail, from 313,076 tests.

Most common reasons for failing

  1. Towbar faultBodywork
  2. Coil springs brokenSuspension
  3. Front or rear fog lamp emitted colour, position...Lights & Electrics

Check the L200 you’re buying

One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.

Finance, stolen, write-off and owner history data provided by Experian.

What the check includes

L200 questions

Is the Mitsubishi L200 reliable?

25% of L200 models fail their MOT based on 313,076 tests analysed. That’s about average for the class. There are 9 known problems to watch for, the most serious being timing belt service. A full history check shows whether a specific car has had related write-offs or insurance claims.

What are the main problems with a Mitsubishi L200?

The most serious known issues are timing belt service, leaf spring fracture, body structure corrosion. Problems vary by generation, so check which apply to the year you’re looking at. Our car check flags whether a specific L200 has been written off or had insurance claims linked to these faults.

How do I check if a Mitsubishi L200 has outstanding finance?

Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.

How do I check if a Mitsubishi L200 has been written off?

Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N L200 has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.

Can I check a Mitsubishi L200 for free?

You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.

What does a Mitsubishi L200 fail its MOT on?

The most common MOT failure on the L200 is towbar fault. 25% of L200 models fail overall, based on 313,076 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.

More on the L200

Other Mitsubishi car checks

Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.