BMW 4 Series car check
Find out if a 4 Series has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.
Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.
- Typical price
- £21,461778 at dealers
- MOT failure rate
- 13.9%4k tests
- Known problems
- 10across F32 to G82
- Full report
- £7.49one-off, no subscription
Which 4 Series are you looking at?
Each 4 Series generation has its own weak spots. Pick the one you’re viewing to see what to check.
-
Crank hub failure (2014-2016 worst)
Safety risk F82The crankshaft hub bolt on S55 engines can loosen over time, allowing the timing gear to slip relative to the crankshaft position. This destroys valve timing and can cause catastrophic internal damage if not caught early. 2014-2016 models are most affected due to inadequate thread locking compound from the factory. BMW issued a service action to inspect and re-torque the hub bolt with improved threadlocker, but not all cars have been updated. This is the most serious documented failure mode on the S55 engine.
What to check: Ask the seller whether the crank hub service action has been completed and request BMW service documentation showing the hub bolt inspection and retorquing. Look for BMW work order references to crank hub or timing gear inspection. Check the service history for any mention of timing-related fault...
-
Oil consumption and rod bearing wear
Engine damage risk F82The S55 engine consumes oil at higher rates than typical BMW engines, particularly under sustained high-RPM operation such as track driving. The rod bearings can show premature wear patterns, especially in cars driven aggressively or on track. This is documented across the S55 engine family and appears related to oil supply dynamics under high-G cornering and sustained high RPM. Regular oil analysis is recommended to monitor bearing condition before audible knock develops.
What to check: Pull the oil dipstick and check the level - it should be between minimum and maximum marks. Ask the seller about oil consumption rate between services and whether they need to top up regularly. Examine the oil condition for any metallic particles or sparkle that could indicate bearing wear. Fresh...
-
Cooling system failures
Wear item F82The S55 cooling system is stressed by the high heat output of the twin-turbo engine and can fail in multiple ways. The electric water pump can fail without warning, the expansion tank and plastic coolant fittings crack from heat cycling, and the system struggles to maintain temperatures during sustained high-load operation such as track driving. The high-pressure cooling system makes leaks particularly serious as coolant loss is rapid once a failure occurs.
What to check: Check the coolant expansion tank level with the engine cold - it should be at the cold fill line. Look for any cracks in the plastic tank or signs of previous coolant loss on surrounding components. Inspect visible coolant hoses for swelling, cracking, or white residue indicating previous leaks. ...
-
DCT clutch wear and overheating
Wear item F82The dual-clutch transmission (DCT) in the M4 uses two clutch packs that can wear prematurely under aggressive driving conditions. Early symptoms include judder during low-speed engagement and slipping under hard acceleration. The DCT cooling system can also struggle during track use, leading to overheating and protective power reduction. This is a known limitation of the M-DCT system when used in high-performance applications beyond normal road driving.
What to check: Ask the seller about any transmission warning messages, judder during parking maneuvers, or slipping during acceleration. Request service history showing DCT fluid and filter changes. Check for any visible fluid leaks around the transmission housing or cooling lines. Look for evidence of track us...
-
Timing chain issues
Engine damage risk F32The N20 engine suffers from timing chain stretch and guide wear, particularly affecting earlier production units. The plastic chain guides become brittle and can fragment, while the chain itself stretches beyond the tensioner's ability to compensate. This causes timing retardation, rough running, and potential interference damage if the chain jumps. The later B48 engine addressed these issues with revised guide materials and improved tensioner design.
What to check: Ask about any rattling noises on startup, rough idling, or engine warning lights related to timing. Check service records for any timing chain work or related repairs. Look for signs of recent major engine work that might indicate the chain has already been replaced. Request any diagnostic scan r...
-
Free play in steering
Wear item F32This indicates premature wear in steering rack components, track rod ends, or steering column joints. The trend is worsening across recent MOT test years, suggesting this is a developing issue with age rather than an isolated problem.
What to check: With the engine off and wheels straight ahead, check steering wheel play by gently moving it left and right - there should be minimal movement before the road wheels begin to turn. Inspect the steering rack gaiter boots for splits or damage that could allow dirt ingress and accelerate wear. Ask a...
-
Oil consumption under hard driving
Engine damage risk G82The S58 engine in the latest M4 can consume oil at elevated rates during spirited driving or track use, similar to its S55 predecessor but generally to a lesser extent. This appears to be related to the high-performance nature of the engine and oil management during high-G cornering and sustained high RPM operation. Unlike the S55, rod bearing issues have not been widely documented on the S58, making this primarily an oil monitoring rather than a reliability concern.
What to check: Check the oil level using the electronic dipstick function in the iDrive system - it should show adequate level without low oil warnings. Ask the seller about oil consumption rates and whether top-ups are needed between services. Look for any oil staining around the engine bay or under the car th...
-
EGR failure
Engine damage risk F32The exhaust gas recirculation (EGR) valve on BMW diesel engines becomes clogged with carbon deposits from exhaust gases, leading to reduced engine performance and increased emissions. This is particularly common on cars used primarily for short journeys where the EGR system doesn't reach optimal operating temperatures regularly. The B47 engine showed some improvement over the N47 but the issue persists across the diesel range.
What to check: Ask about any loss of power, rough idling, or exhaust smoke that could indicate EGR problems. Check for any engine warning lights or diagnostic codes related to emission systems. Look at the service history for any EGR cleaning or replacement work. Ask about driving patterns - cars used mainly fo...
-
Charge pipe failure
Engine damage risk F32The plastic charge pipe connecting the turbocharger to the intercooler can split or detach from its connections under boost pressure. This is a known weak point in the BMW turbo system, particularly on the N55 engine where the plastic becomes brittle with age and heat cycling. The failure causes immediate loss of boost pressure and reduced performance but does not damage other components. Aftermarket aluminum replacements are available and preferred by many owners.
What to check: Ask about any sudden loss of power, whistling noises, or boost-related faults. Check service records for any charge pipe repairs or upgrades. Visually inspect the plastic pipe running from the turbo to the intercooler for any cracks, splits, or loose connections. Look for any aftermarket aluminum...
-
Cold start tapping (hydraulic lifters)
Engine damage risk F82Hydraulic valve lifters in the S55 engine can produce a characteristic tapping or ticking noise during cold starts that typically fades within 10-30 seconds as oil pressure builds and reaches the lifters. This is common across the S55 engine family and usually not indicative of serious problems if the noise disappears once the engine warms up. Persistent tapping that continues after warm-up warrants further investigation for potential lifter failure or oil supply issues.
What to check: Ask the seller whether they notice tapping noises on cold starts and whether these noises persist after the engine warms up. Check oil service history - irregular oil changes can accelerate lifter problems. Ask about any engine work or lifter replacements that may have been carried out.
We haven’t flagged any common problems for this generation in our data yet. A history check still tells you about finance, write-offs and theft, and the MOT history shows how this particular car has been looked after.
What 4 Series cost at dealers now
From 778 used 4 Series we track on UK dealer websites.
- Typical asking price
- £21,461
- Typical mileage
- 49,314 miles
- Price change vs last month
- -0.6%
4 Series MOT results
of 4 Series MOT tests end in a fail, from 3,814 tests.
Most common reasons for failing
- Wheel with a loose or missing wheel nut, bolt o...Wheels
- Tyre cords visible or damagedTyres
- Tyre seriously damagedTyres
Check the 4 Series you’re buying
One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.
Finance, stolen, write-off and owner history data provided by Experian.
What the check includes
- Outstanding finance Experian
- Write-off status Experian
- Stolen vehicle check Experian
- Previous owners and keeper history Experian
- MOT history and advisories DVSA
- Mileage check DVSA
- Known problems for its generation GetCarWise
- How many are left on the road DVLA
4 Series questions
Is the BMW 4 Series reliable?
13.9% of 4 Series models fail their MOT based on 3,814 tests analysed. That’s better than average for the class. There are 10 known problems to watch for, the most serious being crank hub failure (2014-2016 worst). A full history check shows whether a specific car has had related write-offs or insurance claims.
What are the main problems with a BMW 4 Series?
The most serious known issues are crank hub failure (2014-2016 worst), oil consumption and rod bearing wear, cooling system failures. Problems vary by generation, so check which apply to the year you’re looking at. Our car check flags whether a specific 4 Series has been written off or had insurance claims linked to these faults.
How do I check if a BMW 4 Series has outstanding finance?
Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.
How do I check if a BMW 4 Series has been written off?
Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N 4 Series has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.
Can I check a BMW 4 Series for free?
You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.
What does a BMW 4 Series fail its MOT on?
The most common MOT failure on the 4 Series is wheel with a loose or missing wheel nut, bolt o.... 13.9% of 4 Series models fail overall, based on 3,814 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.
More on the 4 Series
Other BMW car checks
Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.