Volkswagen Passat car check
Find out if a Passat has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.
Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.
- Typical price
- £17,363717 at dealers
- MOT failure rate
- 24.3%1.5m tests
- Known problems
- 10across B5 to B8
- Full report
- £7.49one-off, no subscription
Which Passat are you looking at?
Each Passat generation has its own weak spots. Pick the one you’re viewing to see what to check.
-
Oil pump failure
Safety risk B6The oil pump drive chain on BKP 2.0 TDI engines fails without warning, causing immediate oil pressure loss and catastrophic engine damage. The drive chain is undersized for the pump load and stretches until it jumps timing or snaps completely. This is a well-documented failure mode specific to the BKP engine code, with no advance warning symptoms. Later CR TDI engines use a gear-driven oil pump that eliminates this failure mode.
What to check: Check service history for any oil pressure warnings or recent oil pump work - this failure typically occurs without prior symptoms. Listen for any unusual mechanical noise from the lower engine area when manually turning the engine by the crankshaft pulley - a loose or broken chain may rattle. Ch...
-
Cam follower wear
Safety risk B6FSI engines use a mechanical high-pressure fuel pump driven directly by the intake camshaft through a cam follower. This follower wears rapidly due to the high pressures involved and inadequate lubrication design. When the follower wears through, metal debris contaminates the oil system and the fuel pump damages the camshaft lobe. This failure mode is specific to FSI engines and was eliminated on later TSI designs which use a different fuel pump arrangement.
What to check: Check maintenance records for cam follower inspections or replacements - this should be done every 20,000-30,000 miles on FSI engines. Look for metallic particles in the oil by examining the dipstick under bright light - any sparkle indicates active wear. Ask about any fuel system problems or hig...
-
Timing belt service
Safety risk B5The 1.8T engine uses a timing belt with 80,000-mile or 5-year service intervals. This is an interference engine where belt failure causes immediate valve-to-piston contact and catastrophic damage. Belt tensioner failure is common and the water pump should always be replaced simultaneously as it is driven by the same belt. Many B5 Passats now exceed 15-20 years old making belt age more critical than mileage.
What to check: Check service history for timing belt replacement with dates and mileage - any belt over 5 years old regardless of mileage should be replaced. Request proof of water pump and tensioner replacement at the same time - these are mandatory change items. Look for any oil or coolant leaks that may have...
-
DSG mechatronic failure
Wear item B6The mechatronic unit combines the transmission control module with hydraulic valve body in early 6-speed DSG gearboxes. Internal valve sticking and pressure sensor failures cause erratic gear selection, harsh shifts, and transmission faults. This generation of mechatronic unit is particularly prone to failure due to inadequate fluid filtration and heat management. Regular DSG servicing significantly reduces failure risk but many units fail regardless due to design limitations.
What to check: Check the gear selector display for any fault messages or warning lights before starting the engine. Ask the seller about recent DSG service history - units serviced regularly at 40,000-mile intervals are less likely to fail. Request any diagnostic scan codes related to transmission faults - mult...
-
Timing chain tensioner
Engine damage risk B6, B7Early TSI engines use hydraulic timing chain tensioners that fail to maintain adequate chain tension, leading to chain stretch and potential valve timing issues. The tensioner piston seals deteriorate with age and mileage, allowing oil pressure to drop and chain tension to reduce. This causes a characteristic rattling noise on startup that worsens over time. VW issued updated tensioner designs but many cars retain the original problematic units.
What to check: Check service history for timing chain or tensioner work - early replacement indicates the problem was addressed proactively. Ask about startup noises, particularly rattling from the timing cover area during cold starts. Look for oil leaks around the timing cover which may indicate tensioner seal...
-
Sludge buildup
Engine damage risk B5The 1.8T engine is extremely sensitive to oil change intervals and oil quality, developing severe sludge buildup when service intervals are extended beyond 5,000-7,500 miles. The combination of turbocharger heat and narrow oil passages causes rapid oil degradation and carbon formation. Extended drain intervals recommended by VW (10,000+ miles) frequently result in blocked oil pick-up screens, oil starvation, and timing chain tensioner failure.
What to check: Remove oil filler cap and examine inside with a torch - heavy black sludge deposits on internal surfaces indicate poor maintenance. Check oil on the dipstick for thickness and consistency - sludged oil appears thick, black, and may contain solid particles. Look for oil leaks around valve cover an...
-
Turbo failure
Engine damage risk B5The K03 turbocharger on 1.8T engines suffers from bearing wear and shaft seal failure, particularly when oil change intervals are extended or the engine has developed oil sludge problems. Turbo failure typically manifests as blue smoke, loss of boost pressure, and bearing noise. The turbocharger is cooled and lubricated by engine oil, making it vulnerable to oil quality issues that plague the 1.8T engine.
What to check: Check for oil deposits around the turbocharger housing and intercooler pipes - leaking shaft seals allow oil into the intake system. Remove the air intake pipe and examine the compressor wheel for oil contamination or blade damage. Check intercooler for oil pooling which indicates turbo seal fail...
-
Camshaft wear
Engine damage risk B5Pumpe Düse (PD) TDI engines use unit injectors driven directly by the camshaft, creating much higher loads than conventional diesel engines. The camshaft lobes that operate these injectors wear prematurely, causing rough idle, power loss, and eventually complete injector failure. This wear pattern is specific to PD engines due to the extreme pressures required to operate the unit injector system.
What to check: Check service history for camshaft or injector work - worn cam lobes typically require both camshaft and injector replacement. Look for any oil leaks around the cylinder head which may indicate injector seal problems. Ask about any recent power loss, rough idle, or diesel knock symptoms.
-
Dual mass flywheel
Wear item B5PD TDI engines produce significant torque pulses that stress the dual mass flywheel beyond its design limits. The internal damping springs fail, causing rattling, vibration, and eventual separation of the flywheel masses. This problem is exacerbated by the aggressive torque characteristics of the unit injector system which creates more severe combustion pulses than conventional diesel engines.
What to check: Check clutch pedal feel - a spongy or inconsistent pedal may indicate flywheel problems affecting clutch operation. Ask about any recent clutch work - flywheel problems often surface during clutch replacement. Look for signs of recent transmission removal which may indicate flywheel replacement.
-
EGR failure
Engine damage risk B6, B7The exhaust gas recirculation valve on CR TDI engines becomes clogged with carbon deposits, causing the valve to stick open or closed. This leads to rough idle, reduced power, and increased emissions. The problem is worsened by short journey driving patterns and poor fuel quality. Later generations use improved EGR designs but the fundamental issue of carbon buildup remains on all diesel variants.
What to check: Check for any stored fault codes related to EGR operation using diagnostic equipment. Ask about recent power loss, rough idle, or emissions test failures. Look for excessive soot deposits around the intake manifold area which may indicate EGR problems.
We haven’t flagged any common problems for this generation in our data yet. A history check still tells you about finance, write-offs and theft, and the MOT history shows how this particular car has been looked after.
What Passats cost at dealers now
From 717 used Passats we track on UK dealer websites.
- Typical asking price
- £17,363
- Typical mileage
- 49,744 miles
- Price change vs last month
- -24.4%
Passat MOT results
of Passat MOT tests end in a fail, from 1,464,595 tests.
Most common reasons for failing
- Light unit faultLights & Electrics
- Transmission shaft constant velocity joint boot...Bodywork
- Headlight faultLights & Electrics
Check the Passat you’re buying
One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.
Finance, stolen, write-off and owner history data provided by Experian.
What the check includes
- Outstanding finance Experian
- Write-off status Experian
- Stolen vehicle check Experian
- Previous owners and keeper history Experian
- MOT history and advisories DVSA
- Mileage check DVSA
- Known problems for its generation GetCarWise
- How many are left on the road DVLA
Passat questions
Is the Volkswagen Passat reliable?
24.3% of Passat models fail their MOT based on 1,464,595 tests analysed. That’s about average for the class. There are 10 known problems to watch for, the most serious being oil pump failure. A full history check shows whether a specific car has had related write-offs or insurance claims.
What are the main problems with a Volkswagen Passat?
The most serious known issues are oil pump failure, cam follower wear, timing belt service. Problems vary by generation, so check which apply to the year you’re looking at. Our car check flags whether a specific Passat has been written off or had insurance claims linked to these faults.
How do I check if a Volkswagen Passat has outstanding finance?
Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.
How do I check if a Volkswagen Passat has been written off?
Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N Passat has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.
Can I check a Volkswagen Passat for free?
You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.
What does a Volkswagen Passat fail its MOT on?
The most common MOT failure on the Passat is light unit fault. 24.3% of Passat models fail overall, based on 1,464,595 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.
More on the Passat
Other Volkswagen car checks
Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.