Vauxhall Mokka car check
Find out if a Mokka has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.
Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.
- Typical price
- £14,4324,839 at dealers
- MOT failure rate
- 19.1%509k tests
- Known problems
- 9across Mk1 to A
- Full report
- £7.49one-off, no subscription
Which Mokka are you looking at?
Each Mokka generation has its own weak spots. Pick the one you’re viewing to see what to check.
-
AWD coupling failure
Wear item AThe electromagnetic AWD coupling that engages the rear axle on 4WD Mokka variants suffers from internal bearing wear and clutch pack degradation. The coupling unit sits at the rear differential and uses electromagnets to engage drive to the rear wheels when slip is detected at the front. Bearing failure causes vibration and noise from the rear of the car, while clutch pack wear results in inability to engage 4WD mode. This is a known weakness across the PSA/Stellantis AWD system used on multiple models in this generation.
What to check: Check for any 4WD warning lights on the dashboard - these indicate the system has detected a fault with the coupling. Ask the seller about any vibration or noise from the rear of the car, particularly during acceleration or when the system tries to engage 4WD. Look under the rear of the car for a...
-
Timing chain issues
Engine damage risk AThe A14NET 1.4 turbo engine suffers from timing chain stretch due to inadequate tensioner design and extended oil change intervals. The chain connects the crankshaft to the camshafts and when it stretches beyond specification, timing becomes retarded causing poor performance, emissions failures, and potential valve-to-piston contact. This is a well-documented issue across the PSA/Stellantis family of 1.4 turbo engines where the same basic design is used across multiple brands including Peugeot, Citroen, and DS.
What to check: Check the service history for oil change frequency - irregular or extended intervals (beyond 8,000 miles) accelerate chain wear. Ask specifically about any timing chain replacement work and request invoices. Look for any diagnostic fault codes stored in the ECU relating to camshaft position senso...
-
Water pump failure
Wear item Mk1The water pump on 1.4 turbo engines fails due to impeller degradation and bearing wear, particularly on the A14XEL and A14XER variants. The pump is driven by the timing belt on some variants and by the engine directly on others. Failure typically manifests as coolant leakage from the weep hole or complete bearing seizure. This is a known weakness on the GM-derived Ecotec engines where the plastic impeller can degrade and the bearing assembly fails prematurely compared to the intended service life.
What to check: Check the coolant level in the expansion tank - mark the level, wait 24 hours, and check again for any drop indicating a leak. Look for pink or green coolant staining around the water pump area on the front of the engine block. Check under the car for any coolant puddles after the car has been pa...
-
DPF issues
Wear item Mk1The diesel particulate filter becomes blocked on cars used primarily for short journeys where the exhaust system cannot reach the temperature required for automatic regeneration. The DPF traps soot particles and burns them off during highway driving or when the ECU initiates a regeneration cycle. Cars driven mainly in town or on short trips accumulate excessive soot leading to warning lights, reduced power, and eventually complete DPF failure requiring replacement. This issue affects both the 1.6 CDTI and 1.7 CDTI engines and is exacerbated by poor quality diesel fuel.
What to check: Check the dashboard for any DPF warning lights or engine management lights - these indicate the system needs attention. Ask the seller about the car's typical usage pattern - predominantly short trips (under 10 miles) indicate high DPF blockage risk. Request evidence of any DPF cleaning or replac...
-
AdBlue issues
Wear item Mk1The AdBlue (diesel exhaust fluid) system on 1.7 CDTI models suffers from sensor failures, pump blockages, and freezing in cold weather. AdBlue is injected into the exhaust to reduce NOx emissions through selective catalytic reduction. Common failures include the AdBlue pump, level sensor, and injection nozzles becoming blocked with crystallised urea. The system will prevent engine restart if it detects low AdBlue levels or component failure, making this a potentially stranding fault despite not being mechanically serious.
What to check: Check for any AdBlue warning lights on the dashboard - these appear progressively as the system detects problems or low fluid levels. Look at the AdBlue tank level through the filler cap (usually blue cap near the fuel filler) - it should contain clear blue fluid. Ask about any recent AdBlue syst...
-
Suspension joint dust cover deterioration
Wear item Mk1The rubber dust covers protecting suspension ball joints and CV joints deteriorate prematurely, allowing water and dirt ingress which accelerates wear of the protected components. MOT data shows this model fails at 24.4 times the national average for dust cover defects, with the problem worsening over time. The covers become cracked, split, or missing entirely, exposing expensive ball joints and driveshaft joints to contamination. This is particularly problematic on the front suspension drop links and track rod ends.
What to check: Inspect all visible suspension joints for cracked, split, or missing rubber boots - check particularly the front drop links, track rod ends, and driveshaft CV joints at the wheels. Look for grease leakage around joints where the protective boot has failed. Check for any obvious play or looseness ...
-
Exhaust system premature failure
Wear item Mk1The exhaust system suffers from premature corrosion and joint failures, with MOT data showing failure rates 17.8 times higher than the fleet average. The problem is particularly severe on 1.6 petrol engines in the 20,000-40,000 mile range and is worsening over time. Common failure points include the flexible section, centre silencer joints, and mounting points where corrosion causes the exhaust to become loose or develop leaks. The issue appears related to poor quality exhaust components from the factory.
What to check: Visually inspect the exhaust system from underneath the car, looking for obvious corrosion, holes, or loose sections. Check all mounting points and rubber hangers - they should be secure with no obvious sagging. Look for black soot staining around joints which indicates exhaust leaks. Check the f...
-
Handbrake mechanism failure
Safety and MOT risk Mk1The handbrake mechanism fails at 11.2 times the national average according to MOT data, with the problem worsening over time. Common failures include cable stretch, adjustor mechanism seizure, and lever mechanism wear on manual handbrake systems, or actuator motor and mechanism faults on electronic parking brake variants. The rear brake shoes or pads may also wear unevenly due to poor handbrake adjustment, leading to reduced effectiveness and MOT failure.
What to check: Test the handbrake lever or button - it should engage with a firm feel and hold the car on a slope. Count the number of clicks on a manual handbrake - more than 8-10 clicks suggests cable stretch or poor adjustment. On electronic handbrake variants, check that the system engages and disengages sm...
-
Premature suspension component wear
Wear item Mk1Suspension bushes, ball joints, and related components wear prematurely, with MOT data showing failure rates 10.7 times higher than the national fleet average and worsening over time. The problem affects drop link bushes, front control arm bushes, and anti-roll bar bushes particularly. Poor quality rubber compounds and inadequate protection from road salt and debris contribute to accelerated deterioration. This leads to suspension noise, poor handling, and uneven tyre wear patterns.
What to check: Check for any obvious play in front suspension components by grasping the wheel at 3 and 9 o'clock positions and checking for movement. Inspect visible bushes for cracking, perishing, or obvious deterioration - particularly around control arms and drop links. Look for any oil contamination on bus...
We haven’t flagged any common problems for this generation in our data yet. A history check still tells you about finance, write-offs and theft, and the MOT history shows how this particular car has been looked after.
What Mokkas cost at dealers now
From 4,839 used Mokkas we track on UK dealer websites.
- Typical asking price
- £14,432
- Typical mileage
- 23,201 miles
- Price change vs last month
- -4.4%
Mokka MOT results
of Mokka MOT tests end in a fail, from 509,237 tests.
Most common reasons for failing
- Service brake control not releasing correctlyBrakes
- Emissions failureExhaust & Emissions
- Front or rear fog lampLights & Electrics
Check the Mokka you’re buying
One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.
Finance, stolen, write-off and owner history data provided by Experian.
What the check includes
- Outstanding finance Experian
- Write-off status Experian
- Stolen vehicle check Experian
- Previous owners and keeper history Experian
- MOT history and advisories DVSA
- Mileage check DVSA
- Known problems for its generation GetCarWise
- How many are left on the road DVLA
Mokka questions
Is the Vauxhall Mokka reliable?
19.1% of Mokka models fail their MOT based on 509,237 tests analysed. That’s about average for the class. There are 9 known problems to watch for, the most serious being awd coupling failure. A full history check shows whether a specific car has had related write-offs or insurance claims.
What are the main problems with a Vauxhall Mokka?
The most serious known issues are awd coupling failure, timing chain issues, water pump failure. Problems vary by generation, so check which apply to the year you’re looking at. Our car check flags whether a specific Mokka has been written off or had insurance claims linked to these faults.
How do I check if a Vauxhall Mokka has outstanding finance?
Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.
How do I check if a Vauxhall Mokka has been written off?
Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N Mokka has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.
Can I check a Vauxhall Mokka for free?
You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.
What does a Vauxhall Mokka fail its MOT on?
The most common MOT failure on the Mokka is service brake control not releasing correctly. 19.1% of Mokka models fail overall, based on 509,237 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.
More on the Mokka
Other Vauxhall car checks
Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.