Home/Car check/LDV/Maxus

LDV Maxus car check

Find out if a Maxus has outstanding finance, has been written off or stolen, how many owners it’s had, and which known problems apply to the generation you’re looking at.

Finance, stolen, write-off and owner history data provided by Experian. Results in under a minute.

MOT failure rate
31.6%65k tests
Known problems
5across G1
Full report
£7.49one-off, no subscription

Which Maxus are you looking at?

Each Maxus generation has its own weak spots. Here are the known problems.

  1. Vehicle structure corrosion - rigidity seriously reduced

    Safety risk G1

    MOT data shows structural corrosion failures at 66.1 times the national fleet average, affecting all mileage bands from 20k miles upwards. This is not surface rust but corrosion severe enough that MOT testers classify it as compromising the structural rigidity of the vehicle assembly. The pattern suggests inadequate corrosion protection from manufacture, compounded by commercial vehicle use patterns and exposure to road salt and loading stresses.

    What to check: Walk around the vehicle and examine the chassis rails, crossmembers, and floor pan edges for rust perforation or flaking metal. Pay particular attention to areas around suspension mounting points and load bed attachment points. Look underneath the vehicle with a torch, focusing on structural memb...

  2. Brake pipe corrosion and damage

    Safety risk G1

    Brake pipe failures occur at 47.8 times the national fleet average, with the highest failure rate on vehicles under 20k miles, indicating a fundamental design or materials issue rather than normal wear. The pattern affects all mileage bands and has been worsening over the five-year MOT data period. This represents a critical safety defect where brake system integrity is compromised by corrosion.

    What to check: Examine all visible brake pipes from the master cylinder to each wheel, looking for rust scaling, green corrosion staining, or obvious damage. Pay particular attention to unions and joints. Look for brake fluid staining on the ground where the vehicle has been parked, especially around wheel area...

  3. Load sensing valve seizure and failure

    Safety and MOT risk G1

    The load sensing valve, which adjusts rear brake pressure based on vehicle loading, fails at extraordinary rates - 132.4 times the fleet average for seized valves when ABS is not fitted, and 100.7 times average when ABS is functioning. Peak failures occur between 80-100k miles. This component is critical for maintaining proper brake balance on a loaded commercial vehicle, and its failure can lead to rear wheel lockup or inadequate braking performance.

    What to check: Locate the load sensing valve, typically mounted on the rear axle with a mechanical linkage to the suspension. Check the linkage arm for seizure, corrosion, or disconnection. Examine the valve body for corrosion, brake fluid leaks, or obvious damage. Check that the mechanical linkage moves freely...

  4. Wheel bearing excessive play

    Wear item G1

    Wheel bearing failures occur at 75.6 times the national fleet average, with peak failures surprisingly early at 20-40k miles. This suggests inadequate bearing specification for the vehicle's commercial loading patterns or manufacturing quality issues. The problem affects all mileage bands and represents the highest absolute failure count in the MOT data with 6,269 recorded failures across the model range.

    What to check: Jack up each wheel individually and check for play by grasping the wheel at 12 and 6 o'clock positions and attempting to rock it. Any detectable movement indicates bearing wear. Repeat the test holding the wheel at 3 and 9 o'clock positions. Spin each wheel by hand and listen for grinding, rumbli...

  5. CV joint boot deterioration

    Wear item G1

    CV joint boot failures occur at 46.3 times the fleet average, with the highest failure rate paradoxically on vehicles under 20k miles. This suggests poor quality rubber compounds or manufacturing defects rather than normal wear patterns. Once the protective boot fails, contamination and grease loss will rapidly destroy the CV joint itself, leading to expensive driveshaft replacement.

    What to check: Examine the CV joint boots at both ends of each driveshaft for splits, cracks, or missing sections. The boots are rubber or plastic covers that protect the joints. Look for grease spray patterns around the wheel wells or suspension components, indicating a failed boot has allowed grease to escape...

Maxus MOT results

31.6%

of Maxus MOT tests end in a fail, from 65,303 tests.

Most common reasons for failing

  1. Load sensing valve seized or inoperative and AB...Brakes
  2. Seat mounting faultSeatbelts & Airbags
  3. Braking effort inadequate at a wheelBrakes

Check the Maxus you’re buying

One report covers outstanding finance, write-offs, theft and previous owners from Experian, plus MOT history, mileage and the known problems for its generation.

Finance, stolen, write-off and owner history data provided by Experian.

What the check includes

Maxus questions

Is the LDV Maxus reliable?

31.6% of Maxus models fail their MOT based on 65,303 tests analysed. That’s below average for the class. There are 5 known problems to watch for, the most serious being vehicle structure corrosion - rigidity seriously reduced. A full history check shows whether a specific car has had related write-offs or insurance claims.

What are the main problems with a LDV Maxus?

The most serious known issues are vehicle structure corrosion - rigidity seriously reduced, brake pipe corrosion and damage, load sensing valve seizure and failure. Our car check flags whether a specific Maxus has been written off or had insurance claims linked to these faults.

How do I check if a LDV Maxus has outstanding finance?

Enter the registration on this page. We query Experian’s finance database and return any outstanding agreements within a minute. If finance is still owed, the finance company can legally repossess the car even after you’ve paid the seller. At £7.49, you can check before you buy.

How do I check if a LDV Maxus has been written off?

Our check queries Experian’s insurance write-off database for Cat A, B, S and N markers. A Cat S or N Maxus has been structurally or non-structurally damaged and repaired. This doesn’t mean it’s unsafe, but it affects resale value and some insurers won’t cover it. The check costs £7.49.

Can I check a LDV Maxus for free?

You can check MOT history free on GOV.UK, which shows past test results and advisories. What it won’t show is outstanding finance, write-offs or theft markers, which are the things that actually cost you money after you’ve bought. Our full check adds all of that for £7.49, using Experian data.

What does a LDV Maxus fail its MOT on?

The most common MOT failure on the Maxus is load sensing valve seized or inoperative and ab.... 31.6% of Maxus models fail overall, based on 65,303 tests. Checking a car’s full MOT history before buying shows you recurring problems the seller might not mention.

More on the Maxus

Other LDV car checks

Finance, stolen, write-off and owner history data provided by Experian. MOT data from DVSA. Known problems from GetCarWise analysis. Updated October 2026.